Using your appliance

Counting the cubes from a French-door ice maker

Before calling a Maytag French-door ice maker low, run the cube count test: empty the bin, wait 24 hours without using ice, then count. A freezer-only maker should produce 56 to 72 cubes, a refrigerator-section maker 80 to 140, and dual makers 147 to 252. A count in range means the maker is working, and the bin may need 2 to 3 days to fill. [1]

A hand holds a bin of ice cubes lifted from an open freezer drawer, a folded cloth and plastic spatula on the counter.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Cube count over 24 hours: 56 to 72, 80 to 120, 100 to 140 or 147 to 252 depending on the ice maker type. 1
  • A normal count can still take 2 to 3 days to fill the bin. 1
  • Clumping is normal when ice sits unused; humid air and an uncleaned bin add to it. 2
  • Clean the chute, bin and area beneath it every 2 weeks if ice is rarely dispensed. 3
  • No ice at the dispenser: check making ice, locks, Sabbath Mode, paddle, clumps, chute and bin. 5

How many cubes should my ice maker make?#

It depends on where the ice maker sits. Maytag's cube count test gives four ranges over 24 hours: 56 to 72 for a freezer-only maker, 80 to 120 for a refrigerator-section maker with the bin off the door, 100 to 140 with the bin on the door, and 147 to 252 for dual makers. 1

A Maytag French-door refrigerator is built to feed a household that goes to the freezer all day, so ice is part of the daily routine, and a slow bin feels like a failure. A count tells you whether it is. The test is simple, and a number in range means the maker is doing what it was designed to do. 1

Ice maker locationTypical cubes in 24 hours
Freezer only: maker and bin in the bottom freezer56 to 72 1
Refrigerator section, bin not on door: upper left corner80 to 120 1
Refrigerator section, bin on door100 to 140 1
Dual ice makers: one on the door, one in the freezer147 to 252 1
A hand lifts a clear plastic ice bin full of cubes out of an open freezer drawer.
The cube count starts from an empty bin and runs for a full day. 1

How do I run the cube count test?#

Empty the ice bin completely, wait 24 hours without using or dispensing any ice, then take out the bin and count the cubes. Compare your number with the range for your ice maker location. 1

  1. 1

    Empty the bin#

    Take out every cube, so you start from nothing. 1

  2. 2

    Leave the ice alone for 24 hours#

    Do not dispense or take any ice during that time. 1

  3. 3

    Count what the maker produced#

    Remove the bin and count. Lay the cubes out in rows if it helps. 1

    Clear ice cubes arranged in four neat rows of six on a metal baking tray on a kitchen counter.
  4. 4

    Compare with your range#

    If the number is in the range for your type, the maker is working. It may still need 2 to 3 days to fill the bin, depending on usage. 1

If your count falls below the range, Maytag's page links on to more troubleshooting, and this is also the point at which a technician should step in. 1 Unsure where your ice maker sits? The same page shows all four locations in pictures. 1

Why is my ice clumped together?#

Mostly because it sits. Maytag says ice that is not used regularly can clump and fuse together, and calls that normal. Break the clumps up gently with a plastic utensil. Humid air, an unclean bin or a warm freezer can add to it. 2

The page lists four things to check. Is the ice maker used regularly? Does the door swing open often or stay open for long, letting humid air in, and is the seal around the outside doors free of anything stopping the gasket? Does the bin need cleaning with water and a soft cloth, and is it fully dry before it goes back? Is the temperature set correctly? Maytag recommends 0 degrees for the freezer but says you may need to adjust it for the conditions around the unit. Your Owner's Manual describes how to change the setting. 2 Our refrigerator page describes the refrigerator repairs we carry out.

What if crushed ice will not dispense?#

Check that Crushed Ice is selected on the dispenser controls. Then break up any clumps with a plastic utensil, clean the bin and chute, reseat the bin and wipe the chute. Maytag warns not to use anything sharp, because it can damage the bin and the dispenser mechanism. 3

If ice is not dispensed often, shavings can build up, so empty the bin and clean the delivery chute, the bin and the area beneath it every 2 weeks. To clean the bin, remove it, empty it, hand wash and rinse it, and dry it thoroughly before refitting. To reseat it, put your fingers into the hole at the base of the bin, pull the latch, lift the bin up and out, then replace it and press down so it sits firmly. Your manual shows the steps for your model. 3

A hand wipes the ice delivery chute of a refrigerator dispenser with a damp white cloth.
Humid air clumps ice and clogs the chute. A damp cloth, then a dry one. 34

Why does the dispenser give ice at odd moments, or none?#

Two checks cover most of it. On random dispensing, Maytag asks whether the control lock or dispenser lock is on, and whether the chute is clogged. On no ice at all, it adds whether the maker is making ice, whether Sabbath Mode is on and whether the paddle is fully pressed. 45

The lock only turns off the dispenser controls and pad. It does not cut power to the refrigerator, the ice maker or the dispenser light. 45 Sabbath Mode, on models that have it, stops ice and water dispensing, turns off the interior lights and silences the alarm, and exiting it varies by model, typically a 3 second hold of the Sabbath Mode button. 5 Press a sturdy glass firmly against the paddle, because a glass that does not engage it will not release ice. 5

If water comes out and ice does not, and the maker is making ice but not dropping it into the bin, Maytag's page suggests resetting the ice maker by unplugging the refrigerator for 1 minute and checking again a couple of hours later. 5

How often should the ice bin be cleaned?#

Maytag gives two prompts. If ice is not dispensed regularly, empty the bin and clean the delivery chute, the bin and the area beneath it every 2 weeks. And for clumping, a bin that is never cleaned lets ice particles build up and clump. 23

The routine is the one the pages describe. Take the bin out, empty it, wash it by hand with water and a soft cloth, rinse it and let it air-dry fully before it goes back. Wipe the chute with a warm damp cloth and dry it. 23 Dry parts matter, because humid air is what makes ice stick together in the first place. 24

What goes into the visit notes?#

Tell us where the ice maker sits, what the 24 hour count was and what you tried. A photo of the bin and the chute helps.

  • Where is the ice maker: freezer, refrigerator section or both?
  • What was the cube count after 24 hours?
  • Was the ice clumped, and how often is ice used?
  • Is the lock or Sabbath Mode on, and does water dispense normally?

Water around the dispenser, filter area or ice maker is a separate problem; the guide to water at the dispenser, filter area and ice maker covers it, and our ice maker page lists the ice makers we work on.

Sources#

  1. Ice Cube Test - How much ice should my Ice Maker make? - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-01-29; PH 15050 · article text, Possible Solutions
  2. Ice Clumping in Ice Bin - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-04-28; PH 5899 · article text, Possible Solutions
  3. Not Dispensing Crushed Ice - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-12-18; PH 5892 · article text, Possible Solutions
  4. Randomly Dispensing Ice - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-12-18; PH 14721 · article text, Possible Solutions
  5. Not Dispensing Ice - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-12-18; PH 12891 · article text, Possible Solutions

Here to help

Good questions.
Clear answers.

Talk to our team
How many cubes should a Maytag ice maker make in a day?

Maytag's cube count test runs 24 hours from an empty bin. A freezer-only ice maker should make 56 to 72 cubes, a refrigerator-section maker with the bin off the door 80 to 120, one with the bin on the door 100 to 140, and dual makers 147 to 252. [1]

How long does it take to fill the bin?

Maytag says it can take 2 to 3 days, depending on usage, to fill the ice bin completely when the cube count falls in the normal range. A bin that looks half full after one day does not signal trouble by itself. [1]

Why does my ice stick together in the bin?

Ice that is not used regularly can clump and fuse, which Maytag calls normal. Humid air from frequent door openings, an uncleaned bin, or a freezer that is too warm can add to it. Break clumps up gently with a plastic utensil. [2]

Why will the dispenser give cubes but not crushed ice?

Check that Crushed Ice is selected, then break up clumps with a plastic utensil, clean the ice bin and chute, and reseat the bin. Maytag says shavings can build up if ice is not dispensed regularly. [3]

Why does the dispenser give water but no ice?

Maytag asks whether the ice maker is making ice, then whether the dispenser lock or Sabbath Mode is on, whether the paddle is pressed fully, and whether the ice has clumped or the chute is blocked. [5]

Let’s take care of it.

A full hamper waits for no one.
Book the repair.