Error codes explained

After a power outage a Maytag refrigerator

After a power outage, a Maytag French-door refrigerator may show PO, which means the freezer reached 18 degrees F (-8 degrees C) or more. Press Measured Fill under Confirm to acknowledge it, then make sure COOLING OFF is dark, the doors are shut, and note whether the Temperature Alarm is flashing. [1][2][4]

A hand sets a small round thermometer on the freezer drawer shelf of a French-door refrigerator, a flashlight on the counter.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • PO: the freezer rose to 18 degrees F (-8 degrees C) or more while power was off; three tones sound and Confirm blinks. 1
  • Press Measured Fill under Confirm to clear PO. 1
  • COOLING OFF: neither compartment cools, and a few models need cooling switched on again after an outage or surge. 4
  • Temperature Alarm: refrigerator past 48 degrees F or freezer past 15 degrees F, lasting longer than 1 1/2 hours. 2
  • Flashing F: a one-minute pause, cooling confirmed on, then a minute of observation. 5

What does PO mean when the power comes back?#

PO is the Power Outage indicator. Maytag says it shows when the supply to the refrigerator was off and the freezer rose to 18 degrees F (-8 degrees C) or higher. The display reads PO, three tones sound, and Confirm blinks until you acknowledge the outage. 1

That is a record, not a repair message. The control remembers what happened while it had no power, and PO tells you the freezer got warm enough for you to take a look at what is inside. A Maytag refrigerator is built to hold temperature through the day, yet no appliance keeps cold with the supply cut for long.

IndicatorMeaning per MaytagYour action
PO and blinking ConfirmFreezer reached 18 degrees F (-8 degrees C) or more while power was off 1Press Measured Fill under Confirm
COOLING OFFCooling is turned off, so nothing cools 4Turn cooling back on
Temperature AlarmRefrigerator past 48 degrees F or freezer past 15 degrees F, lasting over 1 1/2 hours 2Let it recover, then press Alarm
Door alarmA door left open 2 to 5 minutes with cooling on 3Close the door, check the bins
Flashing FControl needs a reset 5One-minute power pause
The dark control panel above the dispenser of a French-door refrigerator shows five small glowing blue squares.
PO and its blinking Confirm prompt appear on the dispenser panel. 1

How do I acknowledge PO?#

Press Measured Fill under the blinking Confirm. Maytag's page says that once the outage is confirmed, PO vanishes and the panel goes back to its Home screen. 1

  1. 1

    Read the panel#

    Look for PO in the temperature display and a blinking Confirm. Three tones will have sounded. 1

  2. 2

    Press Measured Fill under Confirm#

    This tells the control you saw the outage. 1

  3. 3

    Wait for the Home screen#

    PO vanishes and the usual display returns. 1

  4. 4

    Open the doors only when you must#

    The refrigerator is working to recover, so keep door openings short while it does. 3

Our PO page holds the full text for this indicator.

Is COOLING OFF the reason it is warm?#

It can be. With cooling switched off, COOLING OFF sits on the display and neither compartment gets cold. Maytag notes that a few models stay off until someone turns cooling on again after an outage or surge, and that a wipe-down can switch it off by accident. 4

On many models a shared hold of the Lock and Measured Fill keys for 3 seconds toggles cooling, though the method varies. Press both keys at the very same moment; otherwise the dispenser may lock or another setting may change. Your Owner's Manual lays out the steps for your model. 4 The refrigerator section of our code library lists this page.

What does the Temperature Alarm say?#

It says the cabinet stayed warm for a long stretch. The Over Temperature feature triggers when the refrigerator climbs above 48 degrees F (9 degrees C), or the freezer above 15 degrees F (-9 degrees C), and stays there longer than 1 1/2 hours. 2

Once things cool back down, the sound stops by itself, but the indicator keeps blinking until you press Alarm, which is how the control tells you it happened. If temperatures never settle, Maytag's page directs you to its Temperature Concerns section. 2 The same code library lists it.

Keep the two numbers apart. PO concerns a freezer that reached 18 degrees F during an outage; the Temperature Alarm concerns a freezer above 15 degrees F for a long spell. Each is its own feature with its own trigger. 12

Why does the door alarm sound after an outage?#

The alarm is about doors, not power. A door or the freezer drawer left open for 2 to 5 minutes (it varies by model) with cooling on sets it off, and it repeats every 2 minutes until the door is shut. 3

Outages mean a lot of door opening, so this alarm often turns up afterward. While you sort food, touch any panel button to quiet it; the Door Ajar symbol remains on screen. 3 If it sounds with every door shut, look for bins, shelves or packages holding a door off its switch, and confirm the refrigerator stands level both ways on a level floor. The page adds that cycling power may help and that the alarm volume cannot be changed. 3

What about the food?#

Maytag's pages give temperatures for the indicators, not times for how long food keeps. For what to eat and what to discard, use current federal food safety guidance and the thermometer readings you took. The indicators help you know how warm the freezer got, nothing more.

Keep the doors shut while the refrigerator recovers, and check the freezer first, because PO is defined by the freezer temperature. 1 A reading taken with an appliance thermometer in each section is better evidence than the feel of the packages.

What if a flashing F stays on?#

Try a reset. Cut the breaker or pull the plug for one minute, restore power, check that cooling is on, and observe the display for 60 seconds. Maytag says to schedule service if the F persists. 5

It is easy to mix this up with PO, since both can show up around an outage. PO is something you acknowledge, while F is something you reset. 15 The page text sits in the same library.

What if my refrigerator is a side-by-side?#

Maytag publishes separate pages for side-by-side models with the same family of indicators. This guide follows the French-door bottom-freezer pages only, so look up your own model's pages and manual for exact wording. 12345

On either layout the sequence is similar: acknowledge what the display wants acknowledged, confirm cooling is on, keep doors closed and measure temperature instead of guessing. Whatever a one-minute power pause fails to settle belongs to a visit.

Which details help when you call?#

Say what the display showed and when. A phone photo of the panel, and the thermometer readings with the time you took them, tell us more than a description.

  • Was there a PO, and did you press Measured Fill under Confirm?
  • Was COOLING OFF lit when the power came back?
  • What did the thermometers read in the refrigerator and freezer?
  • Did the doors close fully, and is the unit level?

Top-freezer models, French-door models and side-by-sides are all covered on our refrigerator page.

Sources#

  1. PO Error Code - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-01-27; PH 15040 · article text, Possible Solutions
  2. Temperature Alarm - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-01-27; PH 15045 · article text, Possible Solutions
  3. Door Alarm Light - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-01-27; PH 15042 · article text, Possible Solutions
  4. Cooling Off Indicator Light - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-01-27; PH 15043 · article text, Possible Solutions
  5. Flashing "F" - Error Code - Refrigerator - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2024-04-25; PH 9714 · article text, Possible Solutions

Here to help

Good questions.
Clear answers.

Talk to our team
What does PO mean on the refrigerator display?

PO is the Power Outage indicator. Maytag says it appears when the supply to the refrigerator was off and the freezer temperature rose to 18 degrees F (-8 degrees C) or higher. Three tones sound, and Confirm blinks. [1]

How do I make PO go away?

Press Measured Fill under Confirm to acknowledge the outage. PO then vanishes and the panel goes back to its Home screen. The page lists no other step for the indicator itself. [1]

Why is the refrigerator warm when the power is back?

Check for COOLING OFF on the display. Maytag says neither compartment cools while cooling is off, and a few models stay off until someone turns cooling on again after an outage or surge. [4]

How long does the door alarm wait before it sounds?

Anywhere from 2 to 5 minutes depending on the model, provided cooling is on. It repeats every 2 minutes, and touching any button mutes it while the door stays open, per Maytag. [3]

Does Maytag say how long the food is safe after an outage?

Not on the pages used here. They give temperatures for the PO and Temperature Alarm indicators but no food-keeping times, so follow current federal food safety guidance for what to keep. [1][2]

Let’s take care of it.

A full hamper waits for no one.
Book the repair.