Inside the appliance
Ice maker shutoff arm and switch. In plain English.
The wire arm over the bin tells a Maytag ice maker when to quit: rising ice lifts it to OFF. Product Help names an ice maker that was switched off, by arm, switch or digital setting, as a leading cause of no ice.

Where it fits.
Ice maker shutoff arm and switch in the appliance
Product Help places the switch on the ice maker or inside the freezer, by model.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Ice maker shutoff arm and switch trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag refrigerator frost and condensation
Frost in the freezer and sweating on the refrigerator side of a Maytag French-door unit come mostly from humid air getting in: doors held open, frequent openings, a gasket not sealing, blocked air vents or a refrigerator not level. Some frost in humid months is normal. Rule those out before you book a technician.

Maytag refrigerator leaking water
Water around a Maytag French-door refrigerator usually comes from the supply side, the water filter or the dispenser. Check the supply line and fittings, look the filter over for cracks and missing O-rings, and empty the dispenser drip tray. A leaking filter you cannot replace yet can come out, leaving bypass.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Drop the arm
Lowering the wire arm turns the ice maker on; raising it turns it off.
- 2
Locate the switch
Some models have it under the ice maker, others on the freezer door wall behind the bin.
- 3
Try a reset
Press and hold reset for a few seconds; with no reset button, cut power at the plug for 60 seconds.
- 4
Look at the bin
A full bin lifts the arm and pauses production by design.
Cleaning or replacement?
Leave internal testing to a technician.
Arm lowered, water flowing, and still no ice.
The unit buzzes with the arm raised.
The reset changes nothing.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Ice maker shutoff arm and switch advice. Read the manual for your own model.
- How to Turn the Freestanding Ice Maker On - Product Help | Maytag
- Ice Maker Not Working - Troubleshooting - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
How do I switch a Maytag ice maker on?
Lower the wire arm; certain models use a toggle instead.
Why did production stop?
A full bin raises the arm to OFF. Maytag describes this as the automatic shut-off.
How can I reset it?
Press and hold the reset button, or unplug the unit for 60 seconds.
When should I turn it off?
Maytag mentions long absences and cleaning the bin.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag undercounter ice maker making little or no ice
If a Maytag undercounter ice maker makes no ice, the water filter may not be locked into its housing, which stops production. A clogged filter or one past its schedule can also cut output. Re-seat it, replace it if due, or run without it in bypass until you can.
Ice maker repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

