Inside the appliance
Ice maker ejector arm and jams. In plain English.
Harvest fingers and the ejector arm sweep finished cubes out of a Maytag ice maker. Product Help traces many jams to an ice bridge, where icy water freezes on the stripper and locks the fingers. Free it with plastic only, never a sharp tool.

Where it fits.
Ice maker ejector arm and jams in the appliance
Product Help gives no position; the harvest fingers belong to the ice maker mold.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Ice maker ejector arm and jams trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag refrigerator frost and condensation
Frost in the freezer and sweating on the refrigerator side of a Maytag French-door unit come mostly from humid air getting in: doors held open, frequent openings, a gasket not sealing, blocked air vents or a refrigerator not level. Some frost in humid months is normal. Rule those out before you book a technician.

Maytag refrigerator leaking water
Water around a Maytag French-door refrigerator usually comes from the supply side, the water filter or the dispenser. Check the supply line and fittings, look the filter over for cracks and missing O-rings, and empty the dispenser drip tray. A leaking filter you cannot replace yet can come out, leaving bypass.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Power down first
Stop the ice maker before touching anything.
- 2
Release the ice
Use a plastic utensil to lift jammed ice off the arm so the mechanism is not damaged.
- 3
Understand why
Half-frozen cubes let the fingers lift icy water that freezes onto the stripper on the next pass.
- 4
Restart
Lower the wire arm and watch the following cycle.
Cleaning or replacement?
Leave internal testing to a technician.
The jam keeps coming back.
The arm is bent or stuck.
Cubes are small or hollow.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Ice maker ejector arm and jams advice. Read the manual for your own model.
- How to Troubleshoot the Freestanding Ice Maker - Product Help | Maytag
- How to Turn the Freestanding Ice Maker On - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
What usually jams a Maytag ice maker?
Ice caught around the ejector arm, often an ice bridge on the stripper.
What tool is safe?
A plastic utensil, so the ice maker is not damaged.
How does an ice bridge form?
Fingers lift icy water from half-frozen cubes, and it freezes on the stripper next cycle.
What else lowers ice output?
A kinked water line or a clogged filter.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag undercounter ice maker making little or no ice
If a Maytag undercounter ice maker makes no ice, the water filter may not be locked into its housing, which stops production. A clogged filter or one past its schedule can also cut output. Re-seat it, replace it if due, or run without it in bypass until you can.
Ice maker repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

