What it means
When the panel shows Replace with dashes instead of a percentage, the fridge cannot see a filter: none is fitted, or it is not locked in. Check the filter first.
Maytag ice maker Replace and --% remaining / Water supply
When the panel shows Replace with dashes instead of a percentage, the fridge cannot see a filter: none is fitted, or it is not locked in. Check the filter first.
Also printed as Replace and --% remaining
When the panel shows Replace with dashes instead of a percentage, the fridge cannot see a filter: none is fitted, or it is not locked in. Check the filter first.
It sits in the right-hand side of the ceiling of the refrigerator.
The message stays with the filter locked in.
Your Maytag to-do list, saved here on this device

It sits in the right-hand side of the ceiling of the refrigerator.

The message appears if none is installed.

A filter sitting unlocked is not detected either. Turn it until it locks.

Closing it on a correctly fitted new filter resets the tracking.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
No water filter is installed, or it is not detected because it is not locked into place.
Read the supporting manualOpen the compartment and make sure a filter is there and turned until it locks.
Read the supporting manualReplace stays on until a filter is present and fitted correctly.
Read the supporting manualIf the filter is locked in and the dashes remain, the reading may have failed.
Read the supporting manualManufacturer document
Maytag (use and care guide)
W11401073 Rev. B / p. 16
Scope: Maytag French door bottom mount refrigerator, Use & Care Guide W11401073B. The filter status feeds the water dispenser and the ice maker, which is why it is filed with the ice maker.
The refrigerator cannot read a filter, so it prints --% remaining beside Replace.
Not necessarily. Look at the filter first; it may only be unlocked.
The guide keeps Replace lit while no filter is fitted or the fit is wrong.
The guide does not link this message to ice. A missing filter can still change flow, so refit one.
Maytag codes, symptoms, parts and service
REPLACE in red on a Maytag French door refrigerator means the water filter must be replaced. While you dispense water the word blinks. Fitting a new filter and closing the compartment door resets the tracking.
If a Maytag undercounter ice maker makes no ice, the water filter may not be locked into its housing, which stops production. A clogged filter or one past its schedule can also cut output. Re-seat it, replace it if due, or run without it in bypass until you can.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.